Search results

  1. I

    4l80e 7m

    Might want to check into the RPM limitation of the 80 first, it's not going to be a good match for an I-6 without spending a bunch of $$$
  2. I

    fastest 7mge 0-60s and top speeds

    Mine in very good condition would go GPS verified 124 Max, that was it Asthma followed.....
  3. I

    Furious But Lazy 7M owner who gave Up.

    m8x1.25
  4. I

    fastest 7mge 0-60s and top speeds

    Stock Tach is inaccurate... ;)
  5. I

    The Mistress

    I got some supplied with the W2A IC that came with my blower kit.... I didn't use em they're the Devil's work I tells ya :: IJ. ::
  6. I

    Furious But Lazy 7M owner who gave Up.

    What are your engine mounts like?
  7. I

    Furious But Lazy 7M owner who gave Up.

    The "J" factor ;)
  8. I

    The Mistress

    Hose Clamps ;)
  9. I

    Oil pump drive shaft bearing replacement

    If they're not Sloppy/gouged don't bother, you'll do more damage changing them than you'll prevent!
  10. I

    Good things to look for when buying an MK3?

    Nuh uhhh still a Mk3 :p
  11. I

    Good things to look for when buying an MK3?

    Any car that isn't a Mk3 ;)
  12. I

    7M Coolant flow

    Side note: That Baby is far too happy buy him a Mk3 toy ;)
  13. I

    Need some help, can't seem to figure this out..

    What's the fuel pressure doing?
  14. I

    Furious But Lazy 7M owner who gave Up.

    Personally I'd wait until I had the tune nailed down 100% and the Engine had proven nothing was going to fall off/explode ;)
  15. I

    Looking for thread pitch needed to helicoil the transmission mount bracket bolt holes

    If you buy a helicoil kit you buy it for the bolt size I mentioned, it comes with a drill and an oversize tap.
  16. I

    Looking for thread pitch needed to helicoil the transmission mount bracket bolt holes

    m8x 1.25 from memory
  17. I

    Furious But Lazy 7M owner who gave Up.

    About 100 miles after it was started it was about as good as it was ever going to be Ring Seal and Bearing clearences, from there it's all down hill... This is of course assuming correct clearences/tolerances a clean assembly and correct cross hatch on the bores. Personally I don't go into...
  18. I

    Furious But Lazy 7M owner who gave Up.

    Well and truely "run in" now it's running out.... did you retorque the head before leaning on it?
  19. I

    Anything Needed for an Alignment?

    Wasn't being "funny" at a certain point when lowered you can no longer align the rears correctly as the adjusters run out of travel.
  20. I

    Anything Needed for an Alignment?

    Is it lowered?
Top Bottom