Search results

I would say a few things would play into a sleeper look for a engine bay, but mostly color. Like satin or flat black intercooler piping and intercooler, black rubber boots for the intercooler piping as well. When you put a fuel pressure regulator on, you could look for one that is already...

From talking to friends and family PA state inspection can be a pain in the ass or a walk in the park. It depends on whos inspecting your vehicle, for a down pipe I would suggest a "full 3 inch" down pipe that has the elbow that bolts directly to the CT-26, that way it will all be contained in...

Exhaust looks great! What are you planning for thermal protection on the fuel lines and speedo cable? I got some sleeves from Thermo-Tec at Summit for the fuel lines and speedo cable, A LOT of heat gets pent up there. Also, I'm curious why you left the factory tranny cross-member behind.

I made it down to 15.4 in 86.5 (1/4 mile), cool October night and warm tires, hooked and took off. I was letting out on the clutch during the last yellow light. Had the old school HKS exhaust, test pipe, and a cheap "CAI" filter on the flapper. I have seen 1/8 mile runs, I don't like them...

Sometimes a simple design will make more of an impact than off the wall designs.

Took a day off to go to Carlisle PA for the swap meet, and found a couple of neat shift knobs. I also got my new brake booster for when I pull the engine, this one is for a 86 Toyota Truck. Hopefully this will work out.

Got this in the mail :icon_bigg Pulled the stock shifter out and was amazed how clean my top plate was still since I did the engine swap... This is the fist test fit, before I put the other rubber boots on: So far I'm loving it, I have about 100 miles on it...

Very nice car, its very clean! I love the fact that your wheel cover matches the interior, I have hardly ever seen a matching wheel cover.

Thanks, I'm enjoying it! :) On a update note, here soon, I will be pulling the engine and replacing it with another, from day one the current engine has had somthing wrong with it, but I kept positive to see maybe it just needed to be run, but now its condition is degrading. More to come...

Well its been a while now, I have been enjoying the 1UZ-FE A LOT!!! I have over 7500 miles on my set up as of now, people around here seem to like it a lot as well. Recently I went to a wedding up in State Collage, PA, witch is over a 3 hour drive from where I live. I took a bet and won! The...

Yea, I had used two needle nosed pliers mainly for the spring retainers, ohh and my TSRM, thought it went pretty smoothly though.

I like this one! /\

I went to rockauto and found direct replacements, the quality is great. I've already installed them and have been very happy.

Nice, pulling hard with the top off!

Ok, here are some photos, note; dimensions shown are approximate and depending on the angle you look at them the dimension will seem to change, measure twice "cut" once. I think the hardest part was finding the center of the hatch horizontally, I used string (for future I would suggest wire or...

I put the pre 89 spoiler on my 87, I have mine sitting slightly farther back than the stock placement. I can get come photos/measurments for you soon.

Just found this, allthough the "louvers" are not to my taste at all, it seems like this hood has a raised cowl...

There is a parts wanted section to post stuff like this. You have a PM.

I like the exhaust! When my buddy and me did mine, we couldn't fit the glass packs under there, what length are they?

Nice, how did you mount them? Do the still have full adjustmets?