Search results

is this a common problem that happens?

My car has been sitting for about two months and when I finally got it out I noticed that the steering wheel had a lot of side to side play. You could move it back in forth while driving on the highway and it was not engaging like it should. Any ideas? It also is pulling really hard to the left.

Ok just went out to look at the master cylinder fluid level and it is completely empty.

Can I use any year 86-92 for the master cylinder and slave.

Got ya. Sounds like if I want it fixed thats the route that I will have to take.

Even if there is still some pressure. Could it be adjusting the pedal or fluid. Would like to eliminate possibilities before having to replace parts. Or do you still think that its possibly the master and slave that need to be replaced.

There is no pressure in the clutch pedal (as if there is not even a clutch pedal there) until it is about 1 inch from the floor and then engages. After I release the pedal it only pops up to that point at which it started engaging at the 1 inch point. I can pull the pedal up with foot really...

Yes both programs are on the same lab top. I realize that you can only run one program at a time. I haven't got the point where both programs needed to run at the same time because I haven't figured out why the zeitronix program will not work. I do use the serial port for both program though...

Ok I will check on these things to. I thought that it would have to be the wiring or the the notebook to but I checked the com port and it is correct. Check what with software and hardware configuration? Would the same problem happen with three different computers. As far as the wiring...

Still nothing

Everything seems to be ok. Zeitronix even checked it when I sent the unit to them and everything was ok there to.

I have checked the com ports several times to make sure that it is the right one. So I know that is ok. When I called zeitronix one of the steps we checked was to see if the yellow wire had 5v and it was good. I do have newer software downloaded but I'm positive that this model was made before...

Got ya. I saw it on there web site. But no I don't have one just use the computer. When I bought the car it was already installed. The guy I got it from said it worked when he had it so I'm lost on trying to figure out what it could be. I've tried everything.

Yes used the same usb to serial cable on all three computers. One had a serial connection and tried it and it still didn't work. Not sure what you mean with ZT-2 display Yeah I have the write up and followed as good as I can cause my car is a 88. Just matched the wire codes with the right...

Yes using the newest software and it says no data found but has power.

I just checked the wiring again and the map ecu and the zeitronix wideband share some of the same wires like the VTA wire (TPS), IGT wire (RPM), and the +B1 wire (EFi main relay) for power. The grounds are different the map ecu runs off of E1 computer ground and zeitronix runs off E01 power...

Spoke to zeitronix and they walked me through a series of steps to make sure that it was not anything simple. I have checked power connection and I'm getting 12v. So at least it should show some connection and I'm getting nothing. No tps, no rpm nothing. I have serial to usb port and it is...

Hey guys been doing some research on which intercooler setup that I want to go with and wanted to get some opinions. It seems there are a lot of replica intercoolers out there for 7mgte. The prices are very appealing but not sure on there quality. So I guess what I'm trying to say is other...

Don' know how many people actually order the supra emblem but anyway thought you all should know that I called champion toyota after receiving the toyota emblem for my 88 instead of what I ordered. I guess that when ordering from the online catalog there is a problem with the part number for...

thanks