Search results

Sorry guys but this thread sucks...

So, i just got my new car and since ill be driving it a good bit im looking to get an alarm system. So the way i figure it, i can kill two birds with one stone, buy an alarm with a built in turbo timer. Let me know what you guys have and what you've had sucsess with. i havent had much luck in...

O nice, even better!

Yessss, that DIS-4 definetly went to a good home!!! Awesome numbers Brent, now lets see this thing on your makeshift anti-lag.

Shit, toyota only does bare heads at $1300...

Im contacting champion toyota to get a qoute now, if its not to bad im doing it! Your guys dont have to bad of a price either, im checking on a new one if its to much, then im calling them.

So i just wanted to know, has anyone been through as many heads as me? My first head overheated and as a result of bad maching ended its life, second one had an enormus crack found only after it had been professionaly cleaned, third was entirely to warped had already been milled too much, fourth...

Decel's should be pretty lean, the computer should be just about shutting the injectors off.

so we need an ignitor from a vehicle from 98 and up? will a GTE ignitor work from a 93-98?

Whats the part # on the GT ignitor?

So would 89621-33010 ignitor work? From 92-93 ES300, 93-97 GS300, 92-97 SC300, 92-93 CAMRY, and 94-97 Supra?

this race will never happen...funny vid though.

Didnt know that, i thought there was a difference? Thats usually the first peice everyone lists when they are doing a fascia update project?

Those are damn nice numbers for a stock tune, Good Job! A/f's are getting down there towards the end of the pull.

Meh i would have rather seen another burnout video... So when do we actually get to see the car do some work?

Really? Nobody?

Im aware of correcting the problem with a different head gasket but my question was: How much can i take off of the cylider head surface before i run into "Squish" problems. i presume CCing the combustion chambers would let me know something? Or any other learking problems this would cause.

Thats what i figured MA71. I just got off the phone with cometic, and they said they could make me a 2.5MM thick, with 84.0155mm bore head gasket for $220.I just need to know the very maximum i can take off of the head before i run into piston/valve interferance. On paper, this 2.5mm custom...

Hey guys, whats the absolute minimum headthickness allowed on the 7M. Mine is measuring 4.516, and my problem is that it has already been surfaced for a composite gasket and needs just a light pass before its useable with a MHG. I've already had .015 taken off the block surface, and the mains...

Kickin ass like always. Good job Shawn!