It does work & I mentioned it before!
Your remove the metal ribbed resistor pack it haves a 2 pin connector black-red & a black wire going to it .
You then remove the fuel pump control relay.
Then you insert a jumper from pin 2 to pin 3 of the relay in the same corner.
Pin 2 haves a...
I am currently putting a 1UZ in my 1998 4runner.
The cheap ($250)chinaman stainless 2uz headers bolt onto it better then paying 1200+ anywhere else.
There is many variations
LS400s have front sump 230cc purple injectors
Mechanical clutch fan
SC400 have rear/mid sump with 251cc blue...
Trust me you can build a 2JZ better and cheaper then a high millage 7M the parts for 7M are becoming extinct soon the JZ will be next they are into there 8yr range since the last 2JZ-GTE was made.
You can find aristo 2jz motor auto trans sets for 1400-1600.
This will add a factory base...
The JDM ECU will be fine in US just use the best gas you can when boosting.
The only time you have to worry is when using remapped ECUs Blitz Sard Mines etc..
You never know what injectors mods fuel its designed for since you would have to use an AFC to retune you might as well save the...
if the micro switch at the door locks go bad then just unlocking then opening the door will cause the alarm to go off.
Also if you have the windows rolled down the unlock it from outside it may go off also.
There is 2 switches per door the curtisy light(door jam) & micro switch for the door...
If NOX fails then your to lean or advanced
If HC & CO is high then you have to much fuel or its running retarded on timing.
I think its your Cat & O2 also nevermind other information when HC & CO split meaning one fails and the other doesnt it is very likely to be your Cat & O2.
If you...
On the AC system of my SC400 a lot like the sc300 there is a blue wire for the clutch of the AC
Then there is two wires that go to an AC speed sensor on the pump.
If you car/chassie doesnt read the AC pump speed you do not need to hook these two wires up.
I am surprised how simple it is to...
The traction control TB haves two tps sensors and a stepper motor to shut off a throttle plate causing the engine to bog down when wheels spin.
I dont know for sure but maybe the TPS might have a slightly different resistance not 100%
I am in the proccess of deleteing traction control on a...
I would verify with the relay inplace you have the ~12.5v on pin 4 at the relay by lifting the component or stabing it from the back.
to be sure the contact in the relay is good takes a second to do.
If you have an automatic there is a couple things it can be
Nuetral start switch haves...
Oh no watch out, if making statements based on fact & truth someone will lash out emotionaly calling people idiots from other peoples quotes and say you need to learn more about electronics with out any knowledge of background or education lets attack the truth or fact by calling people...
Dear JET again the starter relay is in series directly between STA IGN SW & the solenoid please read the schematic.
This is fact.
Remember Ω's LAW basics
Here is a series circuite
The current going through R1 is the same in R2 and is the same in R3
If you break the circuite...
^The solution is easy remove the starter relay.
Put a paper clip or tiny 14 gauge jumper wire with solderless spades crimped on it from pin 2 to pin 4 where the relay used to be.
It will then be wired like a Canada Automatic supra
All this will do is disable your factory anti theft alarm...
I know whats wrong actually several things could be wrong.
First off your PCV valve between your intake valve cover & your Plenum is bad or not in place or is even installed in your car backwards!
Because what happins is intake air passes through into your AFM which meters the air and tells...
Keep the VSV it pulls fumes and vapors from the gas tank.
To simplify your car when going single though you can bend the intake tube of the ISCV up a little bit from the water tube just under it.
It used to plumb into the intake of the twins behind the air filter so just remove the tube for...
With the right tune & keeping EGTs down
You can boost to the max effeciency of your twins.
Since fuel cut is at 1bar on the factory MAP Sensor & on the Factory ECU fuel map.
I sugguest only 1Bar of boost as limit because its hard to get good tune when modifing fuel and MAP sensor readings...
I am sorry for being rude, it was 5am, I had to edit this post:
I dont want to waste anyone heres time certainly not mine.
Wrong want to try again?
If that statment was true then JDM & Canadian supras would blow up melt all catch on fire and never start.
The purpose of the starter relay in...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.