no spark no fuel on 7M-GE 4runner swap

[dopeassjackson]

Hey man,

Set the cams at 12 o'clock, set the crank at 0* before top dead center on the compression stroke in cylinder 1. Put the distributor in according to the TSRM: http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?Section=IG&P=17

Start it, let it warm up to operating temp. Jump t1 and e1 in the diagnostic block. THEN set the timing to 10* BTDC.

What year is the motor? 86.5-88 redline is 6500, 89-92 redline is 6250 according to the tachs.

DAMN all data told me to just the T1 and Bi terminal.

 

[shaeff]

Nope, see here:
http://www.cygnusx1.net/Supra/TechTips/engine_error_codes.aspx

Same terminals for checking codes are used when setting the ignition timing.

 

[dopeassjackson]

well i figured it out. dont try to use a supra distributor in a Cressida motor. all is good now.
took the truck on a shake down run in our local wheeling compound. started to mount my winch.

back of winch is about 2in from power steering cooler.

 

[shaeff]

Sweet! By the way, where is "our local wheeling compound"?

 

[dopeassjackson]

Sweet! By the way, where is "our local wheeling compound"?

it wouldnt be a compound if every one knew where it was, it would just be no longer.

 

[shaeff]

Understood. Forget I asked!