Your car did break, that's why you got a different one fool.HellsLegion said:Too bad my car never broke in the first place. No need to get crap done
Who STILL hasn't replaced his turbos?????
Just Another Rebuild
- Thread starter JustAnotherVictim
- Start date
Who STILL hasn't replaced his turbos?????
Probably gonna work on it later today or tomorrow. I need to find something to mount the filer to.
Don't have a vice or a real shop table, lol. I might get a big board just use that.
http://store.summitracing.com/partdetail.asp?autofilter=1&part=PRO-66785&N=700+115&autoview=sku
http://store.summitracing.com/partdetail.asp?autofilter=1&part=PRO-66785&N=700+115&autoview=sku
If you mean engine block yes.
Two in fact....
A few Clamps as well.
I think I see where you're going with that.
Lol yea Kyle I don't count the one since it's fubar.
Two in fact....
A few Clamps as well.
I think I see where you're going with that.
Lol yea Kyle I don't count the one since it's fubar.
Last edited:
Just find a short bolt and bolt it to a block
You could stack a couple to get it up higher or tip one on it's end or bolt it to the engine stand to save your back as this is going to take a couple of hours Ric!
You could stack a couple to get it up higher or tip one on it's end or bolt it to the engine stand to save your back as this is going to take a couple of hours Ric!
Might work with a 1jz but it wouldn't have the Torque to oppose the handle rotation on the filer
hahaha, Wouldn't be able to torque the bolt down hard enough. it would just fall down.
*edit* yes jay! 7M furniture.... I already am looking for a crank to make into a lamp!
*edit* yes jay! 7M furniture.... I already am looking for a crank to make into a lamp!
:rofl:IJ. said:Might work with a 1jz but it wouldn't have the Torque to oppose the handle rotation on the filer
I have a crank I can't use Kyle, come get it and bring the hatch. lol
Jay, Ian will set the roos on you. :runaway:
