Bolt on Big Brake Kit For around 300$.
- Thread starter hvyman
- Start date
the black tts in one of the pic is my rims on dubs car and they fit fine. But 16 inch stockers im not sure.
why does it look so bad like there is a huge non contact area on the picture posted above somewhere.
I'm on cobra breaks, and I have made them fade at the track. All the talk about cross drill being no good.. Why are all porsches, and even my IS-F drilling rotors? Looks? Are you 100% sure on this?
I'm on cobra breaks, and I have made them fade at the track. All the talk about cross drill being no good.. Why are all porsches, and even my IS-F drilling rotors? Looks? Are you 100% sure on this?
I just installed this setup on my soarer and everything bolted up perfect but my wheel (17x8 +35) would not clear the spokes.does anyone know if na mkiv fronts will clear? Or maybe sawblades with a 5mm spacer?
all rotors are cast andthe holes are drilled afterwards. no rotors are cast with holes, this would be virtually impossible. drilled holes are simply chamfered to minimize stress. and yes, oem drilled rotors will certainly crack from the holes.Grandavi;2059047 said:
I cannot seem to find these on eBay anymore! IF anyone can help Id appreciate it. Some are listed as 00-06 calipers are these still the right ones?
Mine was the same. I re-used the stock banjo bolt and fitting on the stock brake lines but they seemed too short or too kinked and I couldn't reattach the small 2-bolt bracket that mounts to the hub/knuckle. I ziptied the bracket and bled the brakes enough for a quick test drive before replacing with Goodridge lines. Same thing on those, a banjo bolt and fitting that will thread into the Merc calipers. They're a little longer than stock lines so I was able to put the factory brackets/clips back in place. I found the brake lines were the only confusing part of this mod, but in the end it worked out for me.
Dm also sells some longer brake lines that are used with the cobra bbk. Used those on my friends car and everything bolted up.
I don't know if any one else is having problems with excessive brake squeals and noise but if so here is the solution
themadhatter;2068270 said:
im having this problem. Care to explain and give some part numbers. your post was a big vague.
to me that looks like a part number on the box and or wrapper, and the item looks like a shim that slides into the pistonsjesse_rc1991;2068560 said:
What pads are you using?
Oem Mercedes pads usually don't squeak.
If they were new maybe you didn't break them in properly?
Oem Mercedes pads usually don't squeak.
If they were new maybe you didn't break them in properly?