Search results

no it doesnt bind or anything the pin fits in the rod smoothly but the bushing looks like its part of the rod it self because theres casting marks on it ill try to take a pic and show everyone what i mean tommorrow. Also, the bolts are really tight in there and i read that it is a must to...

im using full floating pins, i guess there ok then but the bushing looks like its actually part of the rod

my rods came with no bushings at all, but they fit the piston pin really snug, should i get some from toyota and put them in?

hey guys i just got my set of eagles h-beams in today with arp 2000 series bolts. With the sheet they gave me it says the torque specs at 75 pounds to stretch the bolt .0064-.0068 inches. This is just as much as i torqued my main bolts down and it doesnt seem right at all when the tsrm states...

we should all meet up once i get mine running again, ill be shooting for 300 just with basic upgrades.

is that guy in the article reffering to turbocharged motors or would the boost from the tubo actually seat the rings even better?

i have my motor apart and i have read many different theories on positive and negative effects on porting and polishing the head, intake and exhaust manifold. Do you think its really worth the time porting and polishing. Most likely i will leave the head alone but if its worth doing the...

i live in omaha too, red 90 targa not running but will be sometime at the end of june.

how many miles did u put on them?

ok it has come time for me to install the crank and i started sliding the bearings in and i noticed that one of the oil holes doesn't line up. The very first main journal has an off set hole and so does the third and it only came with one offset bearing. I can't find my old bearings to see it...

how do u adjust them, is it like a trial and error sort of thing or how do u know when its at the best time?

http://www.sportcompactonly.com/product.aspx?p=1015&l=2&c=10 -i recently had my head and block milled and i want to run a thinner gasket, would these work well to set the cam timing straight?

would it affect it if i went with a thicker head gasket and how much is a little?

Ok, so my motor has been machined and they bored it .020 over and took .025" of the head and .012" off the block wich equals a total of .037" wich is .94mm off total. -stock headgasket=1.37mm+.94mm=2.31mm will it be ok to just round it down to a 2mm mhg? or will that affect issues like...

hey everyone, Im planning on getting arp head studs and rodbolts, but can you reuse the main bolts, or is it definatly a better idea to get the arp main studs?

i know the ddp sounds sweet but performancewise, does it increase horsepower more than a regular open mouth downpipe would? any results on both types?

gettin my car running hah

how thick is the stock toyota headgasket?

hmmmm. sorry that didnt work....any leaks.. i guess just double check that everythings tight, and the boots are clamped tight on the rack.

i have some, he ships once you pay, we paid a couple days late but as soon as he got the payment he shipped them and i got them 4 days later not a bad product though, i havent tried them out yet.