Just finished a rebuild of my 87t. My battery light is constantly on when the car is running. Put a new battery and alternator in this morning, same problem.
I went to Advance and had them check the charging system, the guy said something referring to a low reading on the alternator's...
the wire comes out of the main wiring harness along the middle of the intake manifold area.
Do you think the previous owner did a knock sensor re-wire? I can't contact the previous owner to ask him.
To trace it I'd have to unwrap the harness but it looks like it's running along the...
I have an extra wire! Both of my knock sensors are wired up and this wire is similar to the knock sensor wire. There is no plug at the end.
It coming off the wiring harness near the fuel injector wires.
Can anyone identify it?
Thanks
Ok, we connected the vaccum line from the intake manifold to the t-connector right behind it on the plastic pipe.
That plastic pipe goes over to the pressure sensor that includes a branch-off to the cruise control unit in between right?
Now the boost gauge reads "0" when idling but when...
On the codes, that's what I thought but just wanted to be sure
We found the plug to the boost pressure monitor was unplugged. The guage now reads -4 at idle but does not move under load
Need a little help. We have three code on the Super Monitor
ECT 0
CC -
ABS 0
ENK ok
The last one is easy. What does the 0 code mean?
Lastly, the boost guage on the dash is pinned at the top whether the engine is running or just the key is on.
Any ideas?
Thanks
So if you put your 89 cruise hub onto an 87 stalk, how did you attach the 89's 4-prong cruise hub to the 87's 3-prong stalk? And what do you mean when you said you pinned out the connections? Do you know which 3 prongs I should connect the 87's cruise hub on the 89's stalk?
Thanks...
I bought a newer (than 87) headlight/wiper combo controls on ebay from someone who said it was compatible from 87-92 mkiii's w/o researching it. The center of my '87 steering wheel has the horn and cruise control on it and the wire harness from it is 3 female. The connection to the later model...
Thanks, I'll make sure the harness is repositioned when I put the motor back in. The wiring harness is supposed to run inside the intake manifold and under the throttle body, right?
I'm almost ready to install the motor after a rebuild. MDC...do you know how much knock sensors go for...
Question refers to this TSRM page:http://www.cygnusx1.net/supra/library/TSRM/ig/IG_21.html
I'm setting the timing on my 7M-GTE. Crank pulley is at the "0" mark, cam pulleys point straight up installed on the center pin of the cam ends, timing belt is installed and tensioned.
When I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.