Search results

  1. destrux

    1jz swapped RX7 questions

    If it's going into a stock (2" I'm assuming) exhaust then you're looking at a pretty big power loss right there, plus with 2 cracked coils you're running on 4 cylinders under boost. Get it all fixed and you'll be doing much better. Turbo motors spew out tons of power with every mod you make, but...
  2. destrux

    Anyone know where I could get the instructions decal for a 1990 turbo?

    Half of mine is there. I think the hillbillies who owned the car before me were chewing on it though, it has some bite marks in it.
  3. destrux

    ***SM Member Horsepower List***

    369.5whp 388.1wtq @14psi (chart title says 15psi, but that's an error) Mods: Stock 1JZGTE, Holset HY35W on tubular manifold, 46mm wastegate, 3" intake w/ K&N, 3" turbo-back exhaust, 100cell metalcat, Circuit 7 MBC, 2.5" IC piping, JDM Sport 3" Intercooler, AFC Neo, 440cc injectors, Walbro...
  4. destrux

    1JZ Oil Pressure with sandwich plate

    Are you using the stock gauge? Maybe it's wrong?
  5. destrux

    1JZGTE Holset HY35W 14psi 369whp Dyno Run

    HY is .65a/r. (9cm) the HX is .89a/r (12cm). The HX has a larger turbine wheel too, I don't know the sizes offhand though. The HY starts to build boost at 2900rpm, 14psi by about 3500. HX is about 600 rpm later on both (on an undivided manifold or a divided manifold with a shared wastegate...
  6. destrux

    DO NOT BUY Powerspirit CT26

    Ebay is flooded with CT26 knockoffs that are designed to fit as upgrades/replacements on the 3SGTE celicas and diesel landcruisers, and even the older 22retc hilux pickups.
  7. destrux

    fuel cut=check engine light

    Speed cut? Are you on a JDM ecu? Pink speed sensor wire still connected to the ECU? 5800RPM in 4th is right where the 118mph speed cut kicks in. If that's the case you can disconnect the pink wire if you have a supra ECU and it will disable the cut. Soarer ECU's use the speed signal for idle...
  8. destrux

    1JZ Oil Pressure with sandwich plate

    You should be running the lightest weight oil that will get you above 10psi per 1000rpm. I run 0W-30 synthetic Mobil 1 in my 1JZ. After a 20 run dyno session where I put down 370whp and oil temps in the 240 degree range, no problems. I get 100psi near 7500RPM. Read this if you're skeptical...
  9. destrux

    help!!! I lock door, I close door, DOOR UNLOCKS :(

    Closing with the handle up doesn't leave fingerprints on the door either if you're doing it right.
  10. destrux

    DO NOT BUY Powerspirit CT26

    It probably fits on one of the other applications for the CT26.... like the MR2, celica, landcruiser.... Seller probably just got his info screwed up when he said it would fit on the supra. Most ebay sellers who order a container shipment of stuff from a knock-off factory in china, slap a...