Search results

I hope not, but my doubts are high. If necessary I will throw rod bearings in it over the winter. It makes good compression, just needs some oil. More info tomorrow when I get at it. For now, I'm pretending like it doesn't exist. :P

no, I'd need the bracket and upper intake from the na with the y-pipe, and I don't want to run that setup. In other news, blew the stock CT yesterday, bad. Snapped the shaft and buried the compressor wheel into the housing. Then, pumped all 7 quarts into the intercooler pipes. 17psi was not...

Good luck man! I'd say daily pills are much better than the adverse of ignoring the issue. Good luck tomorrow. Best wishes on a fast recovery!

I don't know about anyone else, but the title says nothing to me. However, I assume you beat the 350z frumaroll.

Thanks! It's an illusion... A.k.a. I didn't. I am searching for a cressida bracket still, but currently I have mismatched valve covers... :(

Zipties!

Unless it's free, and you can TIG aluminum, It won't be worth the effort when you can buy a drop in upgrade from Driftmotion or ebay.

Funny thing, that's literally how it's done on the 7.3 Ford/International Diesel. My friend did the same to his '03, and that was the instructions. Still runs, but I had and still have serious doubts... lol

Serious update time. I did a shit ton of work this winter, and I'm better and worse off than before, all at the same time. In some kind of particular order, Pulled engine Resealed oil pan, new rear main seal and housing gasket Installed Time-Sert's in the exhaust manifold stud holes...

Whoa, I can't believe I just saw this! Subscribed! Interested in your arm design with the bushings

Is this your engine? That's where your BPV, or bypass valve goes. Unless you have an aftermarket blow off valve on the upper hardpipe, it is hardly advisable to drive it as-is. Even if you have an aftermarket BOV, you should run it as bypass and route it into the intake hose

I use some of everything, mostly Craftsman, but I have a few Mac, SK, and also quite a bit of Snap-On. I've always had luck with whatever I buy... I'm not exactly brand-loyal, I just go with what works

SCICK. I love it!

Two words. HELL YES That kit WILL work with 89+ motor mount brackets on a 7M.

Also, to further the confusion, you can have a 7MGTE and it can still be NA, if there's no turbo hanging off the side.

Makes sense. I was more curious than anything

True, but I swear that the ones on my laptop are on upside down! But on second thought, maybe it's my brain that's on upside down. lol

I just like that you said "yet"! Possible to make it read speed density like the TurboA?

How very true!

That's great pi! I, also, have the same extreme difficulty with the usb port at times. Lol