:biglaugh: ill try things have been going along pretty well I need to send my stuff to a machine shop as soon as i get my hands on a new crank.
SUPRADAN's REBUILD/SWAP/RESTORATION
- Thread starter supradan22
- Start date
group a supra
SPAWNING AN INTERCEPTOR
Well tore apart the JDM TYTE engine to find out its in great shape never had a BHG so the surfaces are in great shape along with the cylinders very happy about that.
A little bit of rust that can be taken care of.
The damage from a spun bearing
The damage from a bad oil pump
Now its off to the machine shop
A little bit of rust that can be taken care of.
The damage from a spun bearing
The damage from a bad oil pump
Now its off to the machine shop
Last edited:
LMAO!
Any reason you want to use the 6M over the 7M Dan?
(I see you have your workshop safety boots on in the first pic!
)
Any reason you want to use the 6M over the 7M Dan?
(I see you have your workshop safety boots on in the first pic!
)
That's why I'm building my 7m block up, and not the 6m.
I figured the 6m block will make a good coffee table, heavy one at that. lol
I figured the 6m block will make a good coffee table, heavy one at that. lol
Well looks like I didnt have a 6m crank in that block I tore apart never seen a 7m a 6m crank together. I figured it was a 6m crank because the block had the pre 89 mounts on it, It was also a Jdm motor that came out of Rays supra so who knows.
Well here are the new pics finnaly got the pics of the motor back from the machine shop.
So nice to see clean cylinders
pics of the new pistions on the refurbished rod
had my crank cut 0.10
More pics soon after it gets assembled.
So nice to see clean cylinders
pics of the new pistions on the refurbished rod
had my crank cut 0.10
More pics soon after it gets assembled.
group a supra
SPAWNING AN INTERCEPTOR
I agree, that looks far to pitted to put a MHG on. That's enough to bite into the MHG & cause a BHG. Thake it back & have it cut some more before you go any further.IHI-RHC7 said:
Well havent really had much time to work on it till now that school is almost out. But this past week end got my turbo harness and ecu and finally assembled the bottom end next week end head gets set on it again and dropped in the suppie.
