no i will not be doing a write up because this is my first one and everyone will have an opinion on this and i dont want to deal with that...it sits 1 inch lower than the bottom of the tank.
Gurley's 92 Teal 2JZ Project
- Thread starter gurley0916
- Start date
ifyouaint1sturlast
Banned Scammer - I'm whitemike.
ifyouaint1sturlast
Banned Scammer - I'm whitemike.
Do you have any more pics of your fuel pump mount? I want to put my A1000 in the same place but all of the bolts that mount to the diff are recessed about an inch. It looks like you have a flat plate of steel?
On a side note, damn you....Your engine bay looks so clean you're making me want to route my wiring harness the same way! I really didn't want to pull the dash.
On a side note, damn you....Your engine bay looks so clean you're making me want to route my wiring harness the same way! I really didn't want to pull the dash.
ifyouaint1sturlast
Banned Scammer - I'm whitemike.
Hey man, how is your heater hoses routed? I was going to cap mine off but I hate losing creature comforts for the sake of cosmetics. Think you can take some close-ups of the turbo side? I had to cut my water pipe to allow it to clear the downpipe.
yes but with using the teflon lines its not as flexible as rubber so i had to make it shoot back to the pump. I didnt go over the tank because the pump is lower.
here is some additional pictures of my pump bracket as requested. The bolts are not tightened yet but that is how the braket will sit
I like the general Idea of that pump mount, maybe cut some of the excess out of it to help cool.? idk just an Idea
ifyouaint1sturlast
Banned Scammer - I'm whitemike.
Oh sorry here you go
the metal hose was cut as short as possible to allow a hose and then two pices were couplered together
the metal hose was cut as short as possible to allow a hose and then two pices were couplered together