Search results

Thanks for the input. I plan to check that out this weekend. If anyone else has additional input, please feel free to add on to what has been said so far. Thanks for the advise everyone.

I have been having this problem for the last few years. While driving there is rattling in the rear, a lot of it. It sounds like the car is going to fall apart at any given minute. Do any of you know what I need to do to fix it. I'm not sure what the cause is.

It was until I figured out it doesn't just slide out. You have to detach that section of links from the rest by loosing the two clips on the side and pressing down the assembly. On the 1.25B link on the bottom you have to unsrew the two screws that keep the link attached, change the link and...

So far I checked the alternator wires and everything is fine. I replaced the fusible link and I still have now power. I don't know if any relay will cause this problem, I don't think so but Im going to research that. An other Ideas, I'm lost.

After looking at your diagram I'm assuming you’re referring to the FL ALT fuse link, mine is the 1.25B since it originally is a non turbo vehicle. I never paid any attention to that because it was just a wire but now I see it is very corroded at the connectors and inside the wire insulation...

(1986.5 with turbo motor swap) Here is what happened. I was joy riding and all of a sudden out of no where I lost power and the car shut off. Nothing when you turn the key, or use funtions that work w/o the key in the ignition such as: dome lights, power locks etc. I broke down outside of my...

Thanks everyone. I should be able to handle that.

I have a clog in the fuel system that I concluded is coming from the tank. I disconnected the fuel line from the tank to fuel filter, started the car and no fuel comes out but you can hear the pump pumping. I never dropped the tank before. Can some one help? If you have any idea where the...

Not exactly sure, suddely it started working, must have wiggled a wire somewhere when checking voltages.

Problem Appears Fixed, Thanks.

Thanks alot for the info Supraguy. I'll have to wait until tomorrow to get some help, but I'll give it a try. Sounds like that may work. Thanks again.

After reseting the ECU I no longer get that code. (after I repositioned it earlier it since I didn't reset the ecu I still got that code) But I still have the same problem. Any Ideas what it can be.

Resently had had starting problems. I took apart my intake manifolds to get to the top bolt on the starter. I removed the TPS from the throttle when doing that. After my starting problem was fixed and everything was put back together when I start my car and give it a little gas and hold it...

Problem is fixed Thanks everyone.

It has been raining but once it stops I will give this a try. Thanks for the info. Hopefully I can find the prob.

Recently my car would not crank when I turned the key. Sometimes after the car sat for hours without trying to start it would start right up. I pulled the starter out and it tested fine. I relized it is the relay not closing the circut. But sometimes it would. I noticed when ever I cant...

I completed a 7MGE to 7MGTE swap two months ago. You will need the following in addition to that motor. Turbo ignitor engine wiring harness ECU must be a Manual Trans. ECU since your converting trannys Turbo AFM downpipe oil cooler, and lines if you are going to overboost...

Thanks alot everyone, so far the problem seams to be fixed. I will rewire the cps. Thanks again.

I Just went out and advanced the timing and it fired right up on the first try without much cranking. I don't know if this was one of those times it randomly fires or if it was just that my the timing was too retard. If it was the angle position does that mean the sensor is good and was just...

Thank you all for your advice, Arpus my tachometer does not move like you stated. I never thought about the CAS, I will try to move it, and tap on it with a hammer. I do have a spare laying around from a running motor, I can try to install when I have the time. I will see if the CAS makes the...