Search results

why would you even post about a mitsu truck with a 2j without posting pics?

was it a blue van, cause he doesn't like red. you gotta watch out for his "man candy" also.

you could get some high grit sandpaper and sand on them to smooth it out if you want. looks pretty good by the way. who sells the can of spray? can you post a pic of it?

save yourself the hassle and get the kit, if you are unsure about putting one together.

i can't believe such a statement. i have to go now, my wife thinks jay is a bad influence:3d_frown:

together and after you lift a little bit, unbolt the ac compressor and power steering pump from the motor, leave the lines alone. you would think that is common knowledge but i have seen people crack the a/c lines as i was yelling to stop. then just bungee cord them to the sides.

keep you ford surfer van thread in the ford surfer van forum.:icon_bigg

nice pics. your supra looks good with that girl next to it. and the 7's look damn good also.

probably wasn't his fault either huh jay?:rolleyes: :biglaugh:

degrease the under side of your car and then hose it off to start off with a clean surface. you would have to pull the tranny to do a rear main seal, it would depend on your mechanic skills if you are able to remove and repair any of your cars' parts.

i loved my toyot t1-s for an all around tire, but i didn't know about the t1-r, so i went with bfg kdw. i don't really like the way they feel when i try to stick them to the road while hard cornering.

all the info you will ever need about the car should be here. nice car and welcome.

damn fine movie. Snatch is also a great one.

hooray for getting rid of the sawblades, but you didn't help much with the contact patch your tires will have by going only half an inch wider.

damn, no progress in 8 days....i hope this means dave is too busy working on his car to have time to get on here to post progress

same shit happened to my auto, i am so happy that i went manual.

beautiful car.

so what in the hell happened to all the posts by "toy-rific"?

you need the support tool and if you are using the profec e-01 to tune it, they need to have similar software in able to communicate with each other. you can also check out www.mohdparts.com for down loadable software and upgrades.

on its way, according to jay the last time i talked to him. it was hesitating when shifting. who is going to do the rebuild for you jay?