Search results

sweet congrats! Pics pics pics pics! LOl

91 always FTW even if it wasn't that clean. Just not rusted to hell or in a accident i'd buy it

get OEM or aftermarket OEM ones. I can get em for about 50 bux a coil

Looks pretty good.... just get it dyno'd

I have a similar issue, at idle .026 gap it has a quick misfire, im going to check on the coils as the plugs are new and see if i need to replace them ugh another 400 down the drain PS i've adjusted the throttle with that little stud/nut combo as i've got cams, it wont hurt anything. It will...

go to autozone/advance and pickup regular vac lines. Silicone hose = more money

IIRC Champion toyota or Elmhurst toyota. $120/140 for all 4 seals for the targa and 60-80 for hatch seal.

I just did a quote i have to hand in the papers then i will get the official quote

wow nice car man, needs a lip ASAP tho heh Just saw the video. Its awesome! Love it

There are alot of wires to worry about Supra*13 1. Extend it 18" IIRC 2. Body harness plugs need to be made up so you have a working cluster 3. Alternator wire needs to be extended from alt to fuse box 4. EA2 connector needs to be wired in 5. http://1jz.com/

do not jack the rear of the car, i had a similar issue when i did this, the engine would not fully sit in place. I lowered the car and it slide into place with a little help from a friend or two. Keep the car level on the ground and try again

alittle salt of the wound ACT > XTD LOL

You never know til you ask the question.....

What year is your car i have a used rack n pinion for sale for cheap if u pickup.

i would be all over it like white on rice

Try this as this worked with me Put the jack at the tail end of the transmission (where the crossmember is). When the engine is tilted and in the bay while lowering and adjusting leveler jack the jack up til it supports the trans slightly. Then as you are lowering and adjusting make sure...

disconnect the module and write down the codes.

rpm signal 1 = pin # 17 - i used that for my SAFC and it works

2. That could be caused by over filling as i've never seen or heard of it happening. Did you put the recommended amount in?

I got my hood & hatch struts from RA and no issues. Its been a few months and ive been opening and closing them both fixing my supra LOL