need help with how to wire Apexi SAFC II on 1J

[juan jz]

Need help wiring up the SAFC-II on my 1JZ if someone can point me in the right direction of where to find the diagram and instructions, thanks

 

[86_sports_1jz]

i have some on my comp i post up later for you but i'm currently at school right now

 

[juan jz]

Thanks that would be greatly apreciated.

 

[aphxero]

http://www.apexi-usa.com/CONTENT/PDF6119.PDF

Use diagram t6-a

 

[Datsrboi]

Question... On the pressure signal wire I notice after searching there were two arguments on which wires which from the safc2 to use. What was the input(from the harness) and what was the output(To the ecu) wires used? I used a DIY diagram from this forum in the DIY section and it said white and yellow wire. Yet on the forum somewhere it was yellow and something else... Can someone chime in?

 

[aphxero]

It's white and yellow.

 

[juan jz]

okay thanks for the diagrams but now im trying to figure out what each wire is i keep looking at the apexi-usa website but what is each wire,

 

[86_sports_1jz]

this is what i used:

RED - Ignition Power

GREEN - RPM signal

BROWN - Ground Wire closer to ECU

BLACK - Ground Wire farther from ECU than brown wire

PURPLE - Knock Sensor

GREY- Throttle position sensor

YELLOW - Air Flow Signal wire going to ECU

WHITE - Air Flow Signal from AFM/Pressure Sensor

BLUE - Optional for Reading Oxygen Sensor Voltage

 

[juan jz]

Thanks I will be wiring it up today