How are your Sway Bars setup?

[CajunKenny]

I was wondering if anyone has setup their S/T Sway Bars (or other brand) in (what they call) ‘Oversteer’ mode/setting. Basically using the inner holes instead of the outer ones.

If so, how did it handle?

My car still has a bit of understeer using the outer holes and would like to minimize that as much as possible.

Thanks…

 

[NashMan]

i leav mine in over streer's more

and to get rid of the low speed under streer i added in jic lower bar helped out alot

 

[Poodles]

My whitelines have 3 holes, I'm on the softest setting front and rear...

Need to find my spacers so I can put em on the hardest setting...

 

[IJ.]

I have the original Prototype set of Whitelines so no adjustments at all.

 

[super.secret.supra.club]

I have the original Prototype set of Whitelines so no adjustments at all.

lol. is everything about you really old? haha

ed.d.

 

[CajunKenny]

i leav mine in over streer's more

and to get rid of the low speed under streer i added in jic lower bar helped out alot

"jic lower bar"? Hmm... I've never heard of it.

Off to do some research...

 

[IJ.]

lol. is everything about you really old? haha

ed.d.

Bastard made me LOL for real

 

[CajunKenny]

Yeah, that was a good one...

 

[tekdeus]

My whitelines have 3 holes, I'm on the softest setting front and rear...Need to find my spacers so I can put em on the hardest setting...

Mine whitelines are both on medium right now. Not sure if I should change it or not; I would like better handling. It seems to understeer lightly when pushed hard.

 

[CajunKenny]

My big concern about putting them on the harder setting is the End Link Tabs holding up. I already broke my passenger side rear one.

My buddy tried to weld it back on; but, it broke again. Argh.......

 

[tekdeus]

My big concern about putting them on the harder setting is the End Link Tabs holding up. I already broke my passenger side rear one. My buddy tried to weld it back on; but, it broke again. Argh.......

True. Luckily I had Randy at BIC weld on his reinforcement tabs. He sells them too I think.

 

[NashMan]

all this reinfrocment tab adding in a brace bs


i used to put blance on them but frankly it was kinda hard to get the bolt off the end link

so this time around i wleded the tab all the way around instead of the that littel stock weld

guess what it never breaks off and hard as fuck on my car and it's easy to take the end link on and off



so befor you do all that jazz just weld it all the way around it whonte break off in less you\buddy can't weld

this is only bean tested on st bars at full over streer

 

[CajunKenny]

Yeah it was a quick fix attempt. He said that it probably wouldn't hold. And it didn't!

Isn't the rule of thumb NOT to weld around the diameter of a rod; but, instead weld lengh-wise down the rod. Regarding strength...and/or weakening...

I'm not sure if I explained that right; but, I thought a rod could be weakened if it wasn't welded on to correctly.

Obviously, I'm not a welder...