Yes I'm bringing back an old thread, but, in searching, I could not find the answer I seek.
I have recently acquired a MAF-T basic set up. In the MAF-T install guide, it says :
Pink - Switched +12volt power source
Black - ground (E2). MAF connector, Pin #1, Brown wire with black dot.
Green - Airflow signal (KS). MAF connector, Pin#3, Pale green wire, brown dot ,black stripe
Brown - Air temp signal (THA). MAF connector, Pin#4, Pale green wire, brown dot
....but in the TSRM EWD, Pin#4 shows to be light blue w/ red (VC) and Pin#2 shows to be light green (THA)
Anyone else run into this? I have both the 87 EWD and the 89EWD, and the Pin-out on the AFM shows the same.