Hey guys.
When I try and make the car start moving I get a horrific grinding sound from the back. If I slowly slowly let the clutch out the car will drive but if there is much load on the drivetrain it grinds to hell.
I have launched the car quite hard a few times.
I have included a video w/ sound so you can hear it.
http://www.youtube.com/watch?v=DXPLA26vIGM
With the car supported on jackstands with the jack as triple support, running in 1st gear everything is spinning. When I press the brake down the driveshaft keeps turning but neither rear axle(CV) turns and there is a huge grinding noise. To me this means something inside the diff is toast. I am open to any other suggestions.
The car is an imported JZA70, so is the diff the same as a USDM car? I can swear I remember an article with Dr. J getting an ebay or other name brand LSD that was made for the non-usdm cars and the axles were different lengths? I am going to do more searching for it but if anyone knows please enlighten me.
Thanks for your time guys.
When I try and make the car start moving I get a horrific grinding sound from the back. If I slowly slowly let the clutch out the car will drive but if there is much load on the drivetrain it grinds to hell.
I have launched the car quite hard a few times.
I have included a video w/ sound so you can hear it.
http://www.youtube.com/watch?v=DXPLA26vIGM
With the car supported on jackstands with the jack as triple support, running in 1st gear everything is spinning. When I press the brake down the driveshaft keeps turning but neither rear axle(CV) turns and there is a huge grinding noise. To me this means something inside the diff is toast. I am open to any other suggestions.
The car is an imported JZA70, so is the diff the same as a USDM car? I can swear I remember an article with Dr. J getting an ebay or other name brand LSD that was made for the non-usdm cars and the axles were different lengths? I am going to do more searching for it but if anyone knows please enlighten me.
Thanks for your time guys.