1uz how to and parts list???

[BOOSTCRAZY]

i found a few threads about 1UZ swapped cars but does anyone know of a step by step how to thread with parts list like we have for the jz swaps. any help would be appreciated. thanks

 

[Chambers]

Off the top of my head for my car:

1UZ-FE From Oil Pan to ECU
W58
W58 cross member
W58 shifter
W58 driveshaft
Quantum Auto W58 Adapter kit
-QA Flywheel
-QA Clutch disk and pressure plate
-QA Slave cylinder/throw out bearing spacer
-QA Clutch Lines
-Bell housing to adapter plate bolts
-Pilot Bearing
1JZ-GTE ARP flywheel bolts
7M-GE pressure plate bolts
Quarter Master slave cylinder/throw out bearing #721-100
Engine mounts
Extend Alt power and regulator wires
Use 1UZ radiator and heater hoses
-Flipped long hose upside down and trimmed accordingly
-Short hose trimmed accordingly
-Extended drivers side heater hose
-Passenger side heater hose was good
Throttle cable from a early 90's Celica
Use stock Supra radiator with electric fans
7M Oil pressure sensor
-Removed the oil pressure switch (dummy light)
-Replaced with 7M sensor
Rear o2 sensor simulators
-4 Resistors # 271-133 (2 packs) 50 ohm wirewond resistors 10watt
-Diod Heat sinks
-Thermo paste
-Super glue
1986 Toyota Truck 4cyl brake booster
Tach driver from a 80’s celica
-Havent found one exactly right yet tho


I believe that’s it for my car...

 

[BOOSTCRAZY]

Thanks a lot 4 the parts list. Can u tell me the best place to find a pinout diagram for wiring up the engine into the chassis (please a link). thanks

 

[Chambers]

No problem, check out my sig, the orange/yellow link. That has all the info you could need for wiring.