14" or 16" Electric fan(s) on my car ?
- Thread starter 87nasupra
- Start date
- Status
i know a few people running the ford contour fans with big hp and no problem.
I believe it is 95-96 v6 contour fans that they use and they fit up very nicely
I believe it is 95-96 v6 contour fans that they use and they fit up very nicely
Chris, the guy that had clutch problems at the supra meet last weekend has those fans on his. He said he dyno'ed at 480 before the new turbo kit was installed. I'd say he had those fans on there then, so they're probably good for as much power as most of us will throw at them.
When I first seen them on his I mistook them for FAL fans.
When I first seen them on his I mistook them for FAL fans.
supraman7mgte said:i have a PWR,and it was one of the best investments i've made. it's been going good for at least 5 years.
WARNING: Do not run stock fan shroud with thicker radiator!!!
when i put my pwr and taco clutch in last summer i ran fine with the stock shroud, why do you need something thinner?
ross
I figured you would have to trim the fan shroud surrounding the stock fan. The PWR rad is probably the largest rad made for the MK3.
I'm no familiar with the contour fan set up but just like any other fan set up u can keep your a/c......i would go with a 14" permacool fan rated at 2950cfm thats 450 more cfm than the dual flexalite setup.......and wire it up to a adjustable temp control switch and u should be right on the money good luck with the route u decide to go with....:icon_bigg
i have the donor car at my parents house so i can start taking it apart tomorrow, hopefully by the time i have it swapped i can figure out what to go with.
- Status