Search results

  1. H

    emissions problem

    I've never dealt with the emissions before. What do you mean by cross counting? I'll check it out. Thanks
  2. H

    emissions problem

    car is stock and I do have a service manuel
  3. H

    emissions problem

    What are the lambda trim system and vf signals? Thanks
  4. H

    Oil Pressure Sensor

    The cap goes on the oil pressure sensor. I you take off the accordian tube and the air intake tube you can look down behind the power steering pump on the right front side of the engine and you'll see the oil pressure sensor. The plug in the cap slids on and the cap holds it on. Hope this helps
  5. H

    emissions problem

    I went to dmv today to get tested and this is the results. carbon monoxide acceptable is 15.00 mine is 35.35 hydrocarbons acceptabe is 1.60 mine is 2.93 I took out the front cat and put on a down pipe. would putting the cat on make the difference with these numbers...
  6. H

    coolant bottle removal

    I'm trying to change out the sensor but I can't reach the bolts on the side. Is there an easier way to get it off? I can't tell but it looks like a couple of bolts on the side on the driver's side of the bottle or does the sensor unscrew or pop out? The manual isn't much help on this. Thanks
  7. H

    Blitz exhaust

    Thanks. after listening to those I think I like the sound of the Blitz the best.
  8. H

    Blitz exhaust

    Is anybody running this and how does it sound? Is it too loud for the street? Can you feel hp gain? Does anybody know where I can get a good price on one? Thanks
  9. H

    Temp light on

    It was low but I refilled it. Do I need to disconnect the battery and reconnect to get this to go away?
  10. H

    Temp light on

    I repaced the water pump, thermostat and the radiator is full of water and the gauge reads a little below center yet my light is on. Does anybody know what would cause this? Thanks
  11. H

    Shakey ride

    I've had this happen on another car but not a supra. Make sure the tranny mounting bolts and driveshaft bolts are tight. If they are loose or missing it causes everything to be out of balance and will have a shimmy as you drive.
  12. H

    transmission noise and window tint removal

    razor blade worked fine on the tint. Anybody know how to remove tint on the back window without tearing up the heating element? Thanks
  13. H

    transmission noise and window tint removal

    Got my car running good but there is a whine in 1st and 2nd that almost sounds like a blow off valve. Anybody have any ideas as to what causes this and how to remedy it? Also, I have old purple window tint that I need to take off. Does anybody know of an easy way of getting it off such as a...
  14. H

    Fresh rebuild won't turn over

    It's been a while since I posted but I did get the car running. I'm a dumb ass. I didn't have any clutch but thought it would get pressure once it started but I forgot that you have a start switch on the clutch and didn't bother to push in the clutch. Thanks everybody for all your suggestions...
  15. H

    Fresh rebuild won't turn over

    Just got back into to town. Thanks everybody for your input. I got it cranking over but can't get it to quite kick over. I've messed the the cps while trying to start with no luck. Any suggestions on this? Thanks!!!
  16. H

    Fresh rebuild won't turn over

    I put the jumper on the small terminal and it did turn over but burnt the wire before it started. I didn't prime it so I don't think the gas got to the engine in time. What does the small wire that goes to that terminal do? Also, thanks for the suggestions everybody.
  17. H

    Fresh rebuild won't turn over

    Decided to disconnect the battery as suggested while on my lunch hour. Still not getting any power. Everything else seems to be working. Any more suggestions? Thanks everybody!!!
  18. H

    Fresh rebuild won't turn over

    The small clip on the starter is connected. When I went to get into the car today the alarm went off. I'll try disconnecting the battery and turning the key to start and see if that does anything. I have to go back to work until 9:30 tonight so I'll try it when I get home.