Search results

Thanks for the link. Oh man do I miss owning a Mk3...

Stick out too far? It should actually fit decently flush.

I think it will. I car I am working on right now is running a 19x11.5 +33 with a 295 tire and there is still inner clearance.

For AEM I would personally use a few members on Supra forums. One is Lawrence (93 twintrbo) from Santa Rosa and the other is Kou (kou xiong) from Sacramento. I know many friends that got their cars tuned with great results by Lawrence. And right now a MK3 I am working on is being tuned by Kou. I...

There was supposed to be one MK3 at the show but it was not finished in time to make it to the show.

Sweet. I will be sleeping with it every night until it is picked up. I will keep it warm for you.

Sure, if you pay shipping both ways.

They are Infiniti FX projectors. As for trimming the radiator support I am not sure. I do know a bit of trimming was done but I am not sure where it was because my friend put the lights in.

Car is finally almost done. Here is a pic of the cut off from the retrofitted headlights It is the new 6000K bulbs on the left and old 4300k on the right

Ya there are more in my old build thread but there are a bunch of pages to go though. When I have time tomorrow I will see if I can find some and post them in here.

Almost ready... Car was fired up the other day to test the redone wiring harness. Harness was pulled out again to wrap it up. Finally this POS is almost ready.

From what I remember West Covina Nissan is a good place to order from. http://www.thenismoshop.com/

I highly doubt that HSD's are made in europe. Both coilovers are made some where in Asia, probably Taiwan. I would not be surprised if they are the same coilover but I am not going to comment on that since i have never seen or used a set of HSD's. I had one of the first Stance GR+ sets in the US...

Hi.

The radiator support area behind the headlight has to be cut out. The rods that allow the headlights to pop up have to be modified to not open as high. Not even close to plug and play.

There have been some brembo kits but I am not sure if they are still available.

With a 3.73 rear end the gearing isn't too bad.

It should clear with out fender work. Yup you are getting it. lol

When I buy tires for my wheels I always try and get them equal or taller in the rear. The middle number of the tires is the height % in relation to the width. So it may seem like the number is larger in the front but in reality the height is actually the same or taller in the rear

^ Dan With the tires you want I would go with the 17x9 +35 and 17x10 +38. I would consider that the nice clean fitment. It should clear with out fender work. And also because you will not be slammed I believe it will look the best over all. Having lower offset wheels + high car = FAIL.