for the past month or so, i would get an intermittent "hard" brake pedal. i attributed this to the very low idle that my car sometimes has.
fast forward to today.... i went on a fairly long drive to pick up some car parts and my car had a slight pull to the right and a front end shimmy around...
i'm picking up a set of FIC injectors for the supra today. yay.
they are #146-550, and are 550's. i just had the flow tested and they were all 630. is this too much to use with a lex afm and afc2?
thanks............
i'm looking to replace my upper i/c pipe and bov. does anyone have any experience with this one?
http://www.ebay.com/itm/TOYOTA-SUPRA-MK-III-1986-1992-INTERCOOLER-PIPE-H-BOV-FLANGE-/110825290065?pt=Motors_Car_Truck_Parts_Accessories&fits=Year%3A1990|Make%3AToyota&hash=item19cdb3b951&vxp=mtr...
i know this is covered somewhere, but i'm looking for some insight.
my car has an intermittent loping idle issue. at least until today, when it never went away. it idles from 1000 to 1800 by itself. if i stab the throttle it either revs higher or idles real low and stalls. it's always...
i need some advice here guys...
i have water getting in my trunk and burning out my taillight bulbs. i've narrowed it down to above the hatch trim panel. is it more likely coming from the spoiler holes or the window trim?
i tried to order new gaskets for the wing, but they were garbage. my...
i'm sure this is covered somewhere, but i can't seem to find it. a friend of mine has a set of rc 550's that i can pick up for cheap. is there a part number or any other way to identify if they will work on my 7m?
this is all i need to be able to use the lex afm and afc and go faster. lol...
i recently bought a "fidanza" flywheel from the for sale section because i knew i could get a replacement disc cheap. when it showed up, it was an aasco flywheel. i've searched, but i can't find the disc for it anywhere.
the question is, should i send it back or keep it and try to find the...
I just picked up a used safcii, but i have no installation instructions. I've looked here and online for them, with no luck.
Does anyone have a good link to the install instructions? There's a few in this section, but none seem to work.
Thanks.... Kevin
my supra wants to idle low and sometimes stall when letting off the gas to slow down. it does it about half the time. if i feather the gas while coming to a red light, it will be ok. when it does stall, it always starts right up.
i was thinking the bov being vented to the atmosphere is the...
long story short.....
i had what i thought was an engine noise, kind of sounded like rod knock. i narrowed it down to the power steering pump. with the p/s belt off the noise would go away, so i ordered a reman one.
skip to today. i hear a lighter metallic clunking sound. when i looked...
like the title says. i need a power steering pump with pps for a 90 supra. i see some on e-bay, but i wanted to know if you guys have a place you trust.
i don't mind spending the money, but i want to get a good one.
thanks.... kevin
hi all. i have a leak from my cps. i plan to change the o-ring on it, but i have a few questions.
i looked up the procedure in alldata, and it says to replace the gear on it. is there a kit that i can buy that comes with the gear and o-ring? would i be better off replacing the whole sensor...
i have an issue with oil smoke out of the exhaust on decel. it happens when i let off the gas and leave the car in gear, but not all the time.
i was leaning towards bad valve seals or piston rings, but someone mentioned it might be the turbo seals.
is there a test that i can do to figure...
i need a new power steering pump for my 90 supra. is there an easy way to tell which kind i have without getting the car in the air?
there's 2 choices....... one with hydraulic reaction, and one without.
i found that cardone has both, but i don't want to order the wrong one.
thanks...
bear with me, as this will be my first rebuild....
i have a freshly rebuilt shortblock ready to go into the car. i'll be using all the parts from my running engine on it. the running motor was rebuilt not long ago, and has arp headbolts, and possibly an hks mhg. the question is..... can i...
i just picked up a rebuilt shortblock from a member in long island. it has a balanced crank, new toyota bearings and rings on stock rods and pistons. everything looks good, but i had a couple questions.
what's everyone's thoughts on having the stock pistons coated at swaintech? i don't...
i'm sure this has been answered, but i can't remember where i saw it.
is it true that a manual ecu has a higher boost cut setting than an auto one?
i read somewhere that the auto one is 8psi and the manual one is 10psi.
the reason i ask, is because i have a 90 with a manual swap done but...
so, my brake fluid is starting to go down a little at a time. i checked the calipers, and the master and there's no signs of leaks. the car is rust free, and all the lines look great. does anyone have any idea where it might be going?
i was thinking maybe there's a leak inside the booster...
i've searched a little, but didn't find a definitive answer.
i'm looking to go with a lexus afm and 550 injectors. i can get my hands on just about any dsm injector out there. my question is.... does anyone know what dsm injectors would work on the 7m? will any of them be plug and play, or...
i have a strange issue regarding my gas tank. sometimes when i remove the gas cap, there's excessive pressure coming OUT. i know that sometimes there can be some vacuum, but i've never heard of positive pressure.
if anyone knows what might cause this, please let me know.
thanks............kevin
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.