Search results

N/A wheels are 16x8 fr, 16x9 rr 50 offset...there's a set w/ new tires on craigslist.com for $450

Where in NC? I lived in Wilmington 18 yrs. I'll be moving back someday. Probably the Durham area.

you need the lamp failure sensor (yellow relay box mounted under the l/h taillight) from an 89+. yours is trying to look for the regular bulb circuit instead of the led in the 89+ spoiler. different resistance i believe.

Great pics! I hope to get to do this soon as well. What suspension mods are you running (if any)?

pull the pump and re-seal it

you can get them from toyota , you just need to determine which ones from a newer toyota would work (mid 90's camry and up ?!?) and order some. the dealer has a chart at the end of each wiring section on the epc that shows you the radius/diameter of the holders. or..... ....junkyard...

Mine came off a RHD car. It takes a little getting used to.

use your existing harness on your 7m, just need to exted the wires for the 3/4 and 1/6 coil pack.

First, I want to say "thank you" to "tookwik". You rock for doing the r&d for this set up! I have been collecting the parts for this mod for a little over a month now, and mocking it up on a spare head I have. I put it all on tonight , and it went together like the parts were designed for...

Spaking of VMIC, is there any advantage to mounting the ic vertical v/s @ an angle, or vice-versa?

SST's come from another source, and are not ordered through the regular parts system, and are $$$$$$$.

63297-14010 X (2) REAR (63297B) 63296-14010 X (2) FRONT (63296B)

the tan wire ,that splits off 3 ways, goes in the connector on the "clip" side.

"st" is the entry level celica. "sr5" was the top of the line in trim on the truck line (p/u, 4runners) which later became the "limited" models, and sr5 became a mid-grade pkg.

O.E. Toyota red contains no phosphates or silicates, unlike the green stuff, which pit aluminum and corrode water passages as well as deteriorate seals.

red + green = brown sludge! you need to flush the whole system (radiator, block, heatercore)

Are you speaking of the "speed-nut" clips? Looks like a clip w/ threads on the back side? If so, you can get those @ just about any auto parts store. I don't see them in the EPC either.

Well, I still don't have it installed. I'm swapping in n/a valve covers, IS300 coil packs, and getting rid of the throttle linkage that runs across the valve covers. I also had to shorten 1 pipe to make it all fit. As far as tuning, I will be setting it up @ base settings, and monitoring it...

Wow. Nice results for what it is! As far as the difference in the look of the previous paint, I believe it would be in the mineral spirits-to-paint ratio. Did you measure each (paint/mineral spirits)? Your mixture is probably off. Could be the moisture in the air due to the front that moved...