Search results

I know thatis what I have been thinking. Do you guys have any ideas of what to check for to see what is wrong? Is there any way that the dyno shop could have got inaccurate readings? The guy said that he couldn't get an accurate tach signal. My tach guge was non-turbo and wasn't working. I have...

well my car will hold boost at 16 psi, it is just a little shaky on the way there.

Well, I dyno'd the other day and had some low numbers. I only dyno'd at 307 wheel hp at 16psi. My car used to be an n/a. It was the first time that I had been, but the guy said that my car ran great except that I was loosing spark at higher rpm. I have my spark plugs gapped at .0028 and as far...

I don't know if it's the gasket, but 300 miles after a shop installed it I noticed moisture down the sides of my block. Titan 2.0mm. Is there maybe rivets that the shop was supposed to remove?

yes, I think there was rivets. Do they all need to be taken off? If so, what holds the layers together, there would then be a bunch of seperate layers not held together. Anyone else know if the rivets have to be removed on a titan motorsports 2.0mhg?

I will take that cover off tommorrow and check, but for now there is no oil any where on the exterior of the front of the motor.

as far as I know, the block wasn't decked, but checked and tuned up by hand. I told them that it had to be perfect for the mhg and they told me that they checked the block and it was good, and that the head was machined.

It doesn't seem to be coming from the valve covers, but can the mhg leak slightly between the layers of the head gasket.

torqued arp studs and nuts to 85 ft. lbs.

I just had (350 miles ago) a titan motorsports 2.0 mhg installed in my 7mgte. Car seems to run and drive great. It dyno'd at 397 to the whhels about a week ago. I noticed a couple of days ago that the sides of the motor are all shiny. The rear area of the manifold side and center of the intake...

I have the venom 550's, and had them for quite some time. I am pushing over 400 to the wheels and they perform great. No problems. Direct plug into stock location.

I'll be there!! Coming from Washington, so hope there is a good turnout. If there looks like there will be then I'm there.