Zeitronix install question

[yankiwi]

Ok, I just finished up my ZT-2 wideband install and I have a few problems.

When I datalog I have good lambda, AFR and RPM. But no TPS or user input (vf).
I see that there is a calibrate function for both of these inputs, which I tried and no luck.

Anybody know if I need to do something with the settings to get this to work???

Oh, its wired correctly. Triple checked that. Good continuity on the soldered connections so I don't suspect the wiring.

Thanks for any help.

 

[isnms]

Which signal did you connect tps and vf to?

check wiring instructions in my sig

 

[yankiwi]

Well, I used your wiring diagram, and verified it with the TSRM and zeitronix instructions. I am certain it is correct.
1989 turbo, TPS is on the red/white VTA, VF is on the grey wire.

Still no luck.

By the way, thanks for putting in the effort to do that wiring guide.

 

[isnms]

Thanks, Glad it was helpful

One guy had bent pins where the zt-2 wire harness connects to the zt-2 control box. See how that looks.

 

[yankiwi]

I will check that.

So I'm guessing from your replies that you didn't do anything special to get it all datalogging? Just wired it up and it all worked huh. No special setup required through the datalogger software?

 

[isnms]

In the software, under Settings > Plots/Comm Port
You have to select which parameters to display.

 

[yankiwi]

Yep, did all that. I thought maybe I was missing something. I am going to pull the wiring and re-solder it, basically verify it all again. See if that helps.