My 7m was just rebuilt and during the reinstall i decided to swap my auto for a 5 speed while i have the car apart, i used the jumper wire to bybass the safety neutral switch and i am almost positive that i have all of the connectors hooked back up and i have tested to make sure that i am getting power to the starter but when i turn the key all i hear is a relay clicking somewhere in the dash, just wanted to see if u guys can point me in the right direction of where to start looking for my problem, thanks
Wont start!
- Thread starter CarNut87
- Start date
http://www.cygnusx1.net/Supra/Library/TEWD/MK3/manual.aspx?S=Main&P=038
There's no more right direction than that...
There's no more right direction than that...
well thankfully now i have the starter turning, the black push in wire on the starter was loose, now i am having trouble getting it to fire i can get it to spit a few times using a small spray of starting fluid but other than that nothing, ive pulled the distributer cap and checked my ignition timing, and ive played around with the adjustment on it. I know that im getting fuel and spark, any suggestions?
other than the plug with the neutral safety switch contacts do i need to do anything to the other two plugs that went to the auto tranny?
FINALLY got it to start, now it wont idle, i pulled the dist cap and checked it and everything looked ok but it runs better at full clockwise lock on the adjustment so im thinking i should slid the distruibuter out and advanse ite one notch clockwise and see if i get any better results, unless there r any other suggestions?