wont let me cancel codes.

[supraman508]

I have 2 codes that are 41 and 51.But when I disconnect both terminals from the battery and wait 3 min and check the codes again they still pop-up,any sugestions?2nd 2nd I can't find in the manual where it shows u how to set the Tps,what section would the setting be at????

 

[OfnaRcR4]

I'd say you still have the problems then.

 

[mkiiichip]

Removing the cables does erase the codes, but those codes get set as soon as the ignition is turned on. So yes it may seem they are not being erased, but as OnaRc4 said, the issue has to go away before those codes will go away.

Here is the section of TSRM you were looking for.
http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?Section=FI&P=100

 

[mk3_7m]

Have you tried removing the EFI fuse ? If that doesn't work then maybe the codes have not been fully eliminated. I can't get rid of 32 since i don't have a HAC sensor

 

[supraman508]

That right I knew I was forgetting something.the DAM EFI FUSE thanks.I saw in the t.s.r.m the section that has the T.P.S picture but didn't show how to install it cause I can rev the engine high with the Tps disconnected but when I connect it it only revs as high as 3 grand.can somebody send me the link to set T.P.S please.

 

[mkiiichip]

Are you serious? Click "next page" in the link I sent you. There is more than one page for everything.
And your TPS is junk.

 

[supraman508]

Thanks mkiiichip still dusting the webs from my cerebral cortex lol.