hey guys i just got a new motor and with my setup with the motor i got a greddy td06 turbo . i was told it was a direct bolt on but apparently its not. so im trying to figure out what adapter flange in need to bolt my td06 to my factory manifold. and also which downpipe will work with that turbo? I was looking into buying a bic divorced downpipe but have no clue to if it will mount. From what i found out that the ct26 is a t2 and the td06 is a t3. So does any one have clue were to get this adapter,elbow and the oil lines that come in the "turbo kit", can i buy them separately?
Where to find adapter, elbow and oil feed lines for greddy td06 to mount of 7mgte
- Thread starter marcmann982
- Start date
do you have a picture. which type of car did that turbo come on.
didnt tdo6 come on the newer evo's
---------- Post added at 01:51 PM ---------- Previous post was at 01:46 PM ----------
yes from what i found they did come on the evo.
if its the one im thinking of they have a funky lookin twin scroll exhaust side.
they should have the mhi (mitsu heavy industries) exhaust flange as well. not 100%.
but if they do then you can get a dp elbow off any mhi turbo and it should fit.
again in you have pics i may have the exact dp elbow that you need. although its stock,
it would save you a lot of time and hassle.
---------- Post added at 01:55 PM ---------- Previous post was at 01:51 PM ----------
as for it bolting to the toyota... not going to happen without a bit of fab work. everything from mani to downpipe. you'll even have to figure out custom (sort of) oil feed and return lines. although i bet summit has some that will work. one place to never skimp is turbo oil lines.
didnt tdo6 come on the newer evo's
---------- Post added at 01:51 PM ---------- Previous post was at 01:46 PM ----------
yes from what i found they did come on the evo.
if its the one im thinking of they have a funky lookin twin scroll exhaust side.
they should have the mhi (mitsu heavy industries) exhaust flange as well. not 100%.
but if they do then you can get a dp elbow off any mhi turbo and it should fit.
again in you have pics i may have the exact dp elbow that you need. although its stock,
it would save you a lot of time and hassle.
---------- Post added at 01:55 PM ---------- Previous post was at 01:51 PM ----------
as for it bolting to the toyota... not going to happen without a bit of fab work. everything from mani to downpipe. you'll even have to figure out custom (sort of) oil feed and return lines. although i bet summit has some that will work. one place to never skimp is turbo oil lines.
i also think that i was looking at another turbo. i think maybe td05 18g rather than td06 20g.
i would just drill new holes in this one.
looks like its got plenty of room.
i would just drill new holes in this one.
looks like its got plenty of room.