Wheel Problems

[Clip]

Hey all,

Dunno if this is the right section (mods please move accordingly), but I have a wheel stuck onto my lawnmower axle. The rear wheel, to be specific. I got the other off successfully, but i think the square pin that locks the wheel to the axle (slides in along a groove in the axle/wheel) is rusted in place. I wd40'd it, heated it, tapped it, beat it, smashed it, petted it, and it wouldn't come off. I pulled out the 5 ton puller and it only hinted at bending the wheel. Any suggestions?

cliffs:

wheel stuck to axle on mower, how can i remove it?

 

[686supra]

just for refference, wtf is a cliff, and whats a IIRC???

 

[OneJArpus]

Cliff notes = summary of the paragraph so you don't have to read it all.

IIRC = If i recall correctly.

 

[686supra]

thanks

 

[Clip]

yeah...now any advice?

 

[kwnate]

pics?

 

[Toyota h8r]

Roll mower perpendicular to ground with bad wheel to the sky. Then, fill the keyway "square hole" with PB BLASTER and let sit. Do this for awile. Then, use a block of wood (4in x 4in) and hammer to pound on axle flush with wheel hub. After that, use a metal rod(3/8in extenion) to pound axle out of wheel. All of this while someone uses a 2x4 board to pry on wheel.(between wheel and frame) ISCLAIMER: oil will leak from motor when on side....