Wheel hop?

[black89t]

ok so its not definite. but if you look closely where its bent its at a fixed point like someone slipped a jack under there and went to town. obviously i don't know for sure but thats what why i said that.


edit: its.....lol

 

[becauseican]

Solid subframe bushings help allot in fighting wheel hop along with beefy trailing/ traction arms....check the BIC section they are in sale now!!!

 

[terror]

so i finally bought a pair of aluminum SS traction arms

but i had a few questions for those of you running these, i cant seem to get both spacers/washers in place as theres just not enough space.
did you guys encounter the same problem, any tips thanks

See washer on left side but not right side.

 

[Poodles]

Thought they stopped making them in aluminum cause they broke....

 

[terror]

i bought these off some guy who never installed them for $170, supra sport told me they only broke when they were tightened without any washers so, im hoping 1 washer will hold through

 

[Toy-Rific]

There are two washers for each side supplied. The reason is that on some t arms the inside opening is wider than the mounting width on the car, so if you do need to fill in the difference in between the two parts you could. You do not want to tighten down the bolt and pull the t arm together. That is why they would break, so use 1 or 2 or noun of the washers in between the two to close the gap and not on the outside of the arm.
Greg Clark