I think you'd have to powdercoat it to make it last to be honest. Still, it looks good in the mean time for cheap!
What did you do to your supra today? Pics
- Thread starter boostinsupra
- Start date
White LEDs, red painted needles, working fuel gauge and a voltmeter gauge, New aem boost gauge in ash tray Along with meth flow gauge, and new apexi turbo timer.
Sent From My HTC One S using Tapatalk 2
I really want to do the LED dash conversion if it's just a matter of switching bulbs then I'd do it but I think there is some re-wiring or something done isn't there?
Numba1Stuna;1912180 said:
Thank you sir
Doat;1912184 said:
Nope just switch the bulbs, it's awesome.
Sent From My HTC One S using Tapatalk 2
BoostMonger;1912208 said:
:aigo: I just found my next project on the car I will be pming you guys with questions in the near future.suprarx7nut;1912216 said:
Doat;1912227 said:
No problem. I conquered it, I'm here to help
Sent From My HTC One S using Tapatalk 2
Doat;1912313 said:
alrighty sounds good! granted iv already put LEDs in my gauge cluster it still good to have info in the open.
what i did today! i pulled the supra out of the garage to air dry (since its nice out side) and added the last quart of Trans fluid. should be good to go now. still need to get a new wheel barring and my down pipe modified. paint comes much later.
462$ to get new passenger wheel barring and down pipe modified. and i have a new brake master cyl on its way from Driftmotion!
Last edited:
Finished what I believe to be the first and only set of functioning EDM rear fogs in a post 89,.
Looks good, tho I don't like them at night. Serves a purpose at least.
I cleaned my dirty girl today
Hopefully the 1JZ will be on the motor stand as of Friday. I took some of the swap parts over to my friends house and cleaned up some space for it. It will be at home with two SC400s til I do the swap
I cleaned my dirty girl today
Hopefully the 1JZ will be on the motor stand as of Friday. I took some of the swap parts over to my friends house and cleaned up some space for it. It will be at home with two SC400s til I do the swap
-Replaced all heater cores hoses.
-Repaired tail lamp failure box. Had a broken solder joint.
-Repaired tail lamp failure box. Had a broken solder joint.
My $.10 coolant cap for the factory twins coolant pipe. Didnt want to have to use a rubber cap that close to the dp. Still gotta figure out how to plug the one coolant port off the rear water pump housing but i think im gunna run a7/16-14 tap in the hole and use a set screw.
And got my lower timing cover and crank pulley repainted and installed
And got my lower timing cover and crank pulley repainted and installed