W58 stuck in gear.

Loki

The Future is Unwritten
Mar 30, 2005
2,766
6
38
39
Prince George, B.C.
Well I picked up a 86.5 NA and the tranny is stuck in first gear, or that's what the guy told me. I can sit in the car and move the shifter around and feel it going in and out, when I push the clutch in the pedal just goes to the floor. When I try and crank the car over it acts like the car is in gear and the whole car just tries to move forward. Pressing the clutch pedal does nothing because it just goes down to the floor.

Last night I pulled the tranny out of the car. I took it all apart so I could see all the gears, levers and such. Everything looks clean, there isn't a bunch of wear on anything and evrything moves freely. There is no sticking when anything moves. There isn't a ton of shavings in the oil either.

When it was apart when it's in Neutral you can grab the input shaft and everything spins freely. When it's put in gear nothing spins. I am completly clueless when it comes to transmissions and am really not sure how it's supposed to be. This is the first trans I've even taken apart. I just really don't get what's going on with it. I'm really hoping someone here can give me some insight into what's going on with it.
 

shaeff

Kurt is FTMFW x2!!!!
Staff member
Super Moderator
Mar 30, 2005
10,589
10
38
Around
did you check the clutch master/slave cylanders? i mean, it might seem as if it's hanging up, but you could just have a problem with the slave not pushing the fork in, and in that case, (if it's leaking badly) you wouldn't be able to put the car in gear when started.

i'm just guessing. i don't know anything about transmissions either, however, i'd start looking at the little things before i pulled it out... :)

-shaeff
 

IJ.

Grumpy Old Man
Mar 30, 2005
38,728
0
0
62
I come from a land down under
Sometimes W58's destroy the nose of the Mainshaft where it goes inside the Input shaft and locks them together with the bearing.

With it in neutral you should be able to turn one while holding the other.
 

Loki

The Future is Unwritten
Mar 30, 2005
2,766
6
38
39
Prince George, B.C.
Hmm.....well I'm going to try and replace the slave cylinder tomorrow (if my friend orderded it) if not I'm going to have to start calling around asking if anyone in town has one....that should be fun.....

Also going to replace the clutch master and then give it a shot and see what happens.