VPC install?

[7m2ner]

Hey everyone, so I fould a thread to install the VPC, and on the thread it says that the grey wire that should be there, and of all teh four wires I dont have a grey one, I have a yellow wire. I was wondering if I should move the pin location on the harness so that it matches the grey wire comming out of the vpc, if I am correct it use to be in a mk4, so that might be why its diffrent. This is the thread I found. http://www.supramania.com/forums/showthread.php?t=97921&highlight=SAFC&page=2
This is what I have

 

[Bondango]

It dosnt matter what the VPC was from, as they all use different wiring configurations for different types of AFM, As long as you use the wires emerging from the VPC and not those on the second plug. Just repin the second plug so you have connections to the 4 wires needed (and ensure the dip switches are set too)

 

[gofastgeorge]

I have personally wired up 3 VPCs meant for a Nissan (yellow wire).
And you are correct, move the Yellow wire to wherethe Grey wire is supposed to be.
That is the feed to the ECU for the Toyota Karmen signal.
The yellow wire, where it's at in the harness is for the MAF (hot-wire) feed into the Nissan ECU.

Don't forget the required resistors for the 7M.
And make sure you use the correct ones for your ECU.
They are different from the early, to the late ECUs.