Time for a 4"

[tissimo]

Im going to put my 3" catback on my DD and upgrade to a 4" on the blue car..

Where is a good place to get 4" tight radius bends at? 90* will work fine, but not sure where to get them though..

 

[Stretch]

Burns stainless would be my choice.
http://www.burnsstainless.com/304tubing/Lbends304/lbends304.html

Just so I give you more than one option, here's ATP
http://www.atpturbo.com/Merchant2/m...OD&Product_Code=ATP-STL-021&Category_Code=STL
eric

 

[rakkasan]

I recommend global tech. The link if for 4" 304SS, but you can change as needed.

I bought 3" 304SS (straight & bends) from them for my exhaust along with 3" aluminum for my IC piping. I was quite pleased with their service & prices. I think I paid about $300 shipped for all of my stuff, which is quite cheap when considering that I bought ehough to do both my IC piping & my exhaust.

 

[tissimo]

Gloabal tech is cheap! but 6" CLR where as atp is 4CLR but more.. i wonder if I can fit 6.... I Dont remember what i used for my 3" dp

I know I ordered off summit and they only have 6 and 4.5.. i guess i'll measure when i get home

what about a vbandkit .. lowest i found was like 80$..

 

[rakkasan]

Gloabal tech is cheap! but 6" CLR where as atp is 4CLR but more.. i wonder if I can fit 6.... I Dont remember what i used for my 3" dp

I know I ordered off summit and they only have 6 and 4.5.. i guess i'll measure when i get home

what about a vbandkit .. lowest i found was like 80$..

I think you'll be hard pressed to find a smaller radius that what GT offers. Let me know what you find though....

Edit: I see you found 4.5", but is that inside, outside or centerline radius? GT's radii are measured at the center line.

 

[tissimo]

4" Center Line Radius at ATP.. 45$ vs 30 though..

the 3" that i used from summit was either a 4.5 or 6..

I'll prolly do 1/2 and 1/2 though.. 2 from atp and the rest from Global tech.. i need to order couplers and a 3->4" adapter pipe from them anyways (ATP)

damn aluminum is cheap! cheaper then steel.. maybe I should get argon so I can weld aluminum with my mig.. (for my ic piping)