There is hope for your alignment.

[87witmoreboost]

Sent my car to be aligned today, post-lowering.

Car has RS*R Race Springs and I was told by many to order camber kits.

Alignment went perfect and was aligned to spec on stock adjusters.

 

[ValgeKotkas]

Well...my bolts are rusted and therefore stuck. No alignment for me (until I get new bushings )
You are one lucky man I think...

 

[themadhatter]

I have tanabe gf210 springs and even after an alinment the rear camber is still way off and nothing was frozen or rusted in the suspension

 

[shaeff]

Lots of people's cars aren't in that nice of shape, especially on the undersides. The tabs for the eccentric bolts tend to bend over, which is why everyone should clean them, bend them straight, and run a bead of weld behind each one to prevent it from happening again.

That, and if you go too low, it won't be good no matter what... I believe the lower transverse arm is to blame.

 

[HommerSimpson]

I took a look before i compleatly modified mine... but you can enlongate (sp) that slot and gain some...on the lower arm...you would have to bend tab over and then weld tab on inside of the outer tab to push arm further in...
but its very dooable... so for those that want to fix just pop one bolt out and take a look ( 10 min job if not rusted )... you will see...

 

[tsuper92]

new hampshire car and the bolt's weren't frozen.you sir might want to go buy some lottery ticket's

 

[fstlane88]

Sent my car to be aligned today, post-lowering.

Car has RS*R Race Springs and I was told by many to order camber kits.

Alignment went perfect and was aligned to spec on stock adjusters.

Where did you go to get your alignment done, j/w?

 

[87witmoreboost]

Got it done at a local tire shop in New Hampshire. I got the printout and it's all within spec.