the graph from tx2k8

gixxer750

2jzget comingsoon!
Mar 30, 2005
2,333
0
0
Mississippi
Here is my dyno graph at 16 psi from tx2k8 from the one dyno pull I did. Car reved to 5k rpm.... and as you can tell, the power had not near peaked and flattened yet. I think it would have made.... 475ish on 15 psi, and much more had it reved enough to make more boost. 4th gear pull with 3.91's and 275X40X17's. So you figure it up, but aem says it was 5krpm.

p988478_1.jpg
 

turbojuiced

New Member
Apr 5, 2008
343
0
0
San Diego/Fairfield
it looks as if you started to pull timing at around the 92-93mph range. Not too sure why it doesnt show rpms? As my graphs in the past have been dynojet and a few mustang dyno charts.


However, you can see where it started to taper off then it picks back up a little before peaking out.