T3/T04E Turbo application...

[ggeiss240sx]

I have a Garrett T3/T04E turbo that I used for my s14 240sx and it worked great. I was just wondering if this would be a good turbo to use on the 7m or would the exhaust housing be too small?

-60 trim T04E compressor wheel with a max flow rate of 53 lb/min
-0.60 AR T04E compressor housing

Thanks much!

 

[IJ.]

Might drop off at around the 5000 rpm mark.

I used a .63 on my old GT30R and could tell the 7M wasn't breathing as well as it needed to.

 

[IHI-RHC7]

What is the A/R of the exhaust side?

 

[Timmer]

As IHI said, what's is the exh housing a/r and exh wheel trim. That cold side should flow over 400 whp at 20~ lbs, with a .82 a/r and large trim wheel iirc..

 

[IJ.]

Sorry I just made the assumption that it was speced for a 2 litre it would have a smallish wheel/tight AR to go with that Compressor. (should really have waited for GG to post more info)

 

[ggeiss240sx]

Sorry it doesnt even say the size on the exhaust housing, it roughly half the size of the compressor, or the average t3 size.

 

[Timmer]

Sorry it doesnt even say the size on the exhaust housing, it roughly half the size of the compressor, or the average t3 size.

Hard to say, most likely it's a .48 if it was purchased for a 4 cyl setup in the first place.