Subframe bushing install

[enjoi.this]

Picked up some nylon bushings from BIC performance and am ready to install. I haven't really looked closely to see what kind of job it is. But can I get away with just lowering the sub frame enough to swap the bushings out without pulling the diff, drive shaft and so on?

 

[becauseican]

Yes you should be able to lower the subframe enough to get the spacers in. You will have to pull the rear seat bottoms out and plastic plugs in the trunk to get to the subframe bolts, you may have to pull them up a bit to get the spacers in. There is some info on the spacer thread in the BIC section.

 

[enjoi.this]

Awesome that will save alot of time on the install.

 

[NashMan]

i have never taken my seat's out

 

[Satan]

Pages 10 & 11...

http://www.supramania.com/forums/sh...-Front-amp-Rear-Subframe-Poly-Bushings/page10

Good luck!

 

[enjoi.this]

Thanks for the info satan but I only did the spacers for now (I should have been more specific)

Glad those old spacers are out since they were pretty pounded out.. Very easy job to say the least!

 

[92nsx]

Pages 10 & 11...

http://www.supramania.com/forums/sh...-Front-amp-Rear-Subframe-Poly-Bushings/page10

Good luck!

I only show 4 pages total

Telling the post #'s works better for us that show more then 10 post a page

 

[Satan]

^^Didn't think of that, thanks...

Starts at post #98, in this thread. http://www.supramania.com/forums/showthread.php?89326

I was a bit intimidated before starting, not having pics or tips, etc. So, provided what I went thru in the process and suggestions. Please feel free to improve upon the notes/tips/pics.

-E