Standard Engine Bearings Table.

[supramen]

The standard engine bearings table. on:
http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?Section=EM&Page=73
is not helping me coz its not a full table! does any one have a better table? if you do it would be most helpfull

 

[Nick M]

Huh? What are you trying to figure?

1 + 2= 3.....1 + 1= 2

 

[bwest]

go back one page (72) that is the part you are missing
http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?Section=EM&Page=72

 

[supramen]

sorry lads i didnt make it clear, the table im using gives the measurement for the crankshalft mains and the block, i need to know what size the crank and block should be for bearing size (4) but there are just two blanks spaces there. and for bearing (3) i need to know what size the crankshaft is? and the same with (0)
i dont trust the 2+1=3 way, things wear out! and evey think as to be very close or i will get low oil pressure! but thanks for the replys men!