Spec stage 5!?!?!
- Thread starter Justin727
- Start date
I have a feramic disc with an aluminum flywheel(fidanza), as far as I know the friction surface of the flywheel is steel.
kwnate said:
I pretty sure you are correct. I'm looking at mine & it sure looks like steel to me.
well I wont be running a fidanza had my stuff balanced with the stock flywheel. Didnt want to go thru potential problems with fidanza.
So i think seans setup sounds ideal for what im looking for
So i think seans setup sounds ideal for what im looking for
I got a stage 5 Act clutch for sale Brand new for sale in Parts Clutch disc,presser plate,throwout bearing ,polit shaft bearing,alinment tool,$575 shipped ( Edit ) (Downsizing my build) Pm me
well since no one has bumped this thread or posted much I think im going to stick with the RPS MAXX PP and HPF bronze disc
bringing this thread back how did yur setup work out??? i think my spec 3 is starting to go and im looking into the spec 3+ or RPS......Justin727 how did yur setup go???
well i havent heard anything about those 2 being tried yet.
But i did infact settle for the RPS and HPF disc. Like X-man has. Havent been able to drive her yet but if sean says its good then i have no doubts it'll be fine for me!
My engine is still on the stand
But i did infact settle for the RPS and HPF disc. Like X-man has. Havent been able to drive her yet but if sean says its good then i have no doubts it'll be fine for me!
My engine is still on the stand
im going to bump this off,
im stuck between the spec 3+ and the RPS stage 3, there are lots of high hp people in here so its great!
I need to know if I should spend the $$ to get the hpf kit, or if ill the stock stuff from spec and rps will be fine.
also on the flywheel subject, the fidanza is, or isnt fine? if it has a steel friction surface, it should be fine no?
thanks in advance,
Jon
im stuck between the spec 3+ and the RPS stage 3, there are lots of high hp people in here so its great!
I need to know if I should spend the $$ to get the hpf kit, or if ill the stock stuff from spec and rps will be fine.
also on the flywheel subject, the fidanza is, or isnt fine? if it has a steel friction surface, it should be fine no?
thanks in advance,
Jon
sean aka Xman has ran with the RPS and HPF disc combo to much success. I have the RPS MAXX 3200LB PP with HPF bronze disc and SS braided clutch line.