Spec II

xXxICExXx

New Member
Aug 6, 2006
366
0
0
40
Abbotsford, BC, Canada
I just finished installing it an hour ago, took me 4 hours from start to finish. Its my first boost controller and its a little intimidating:icon_bigg I understand what everything means and what it does but obviously I dont know for sure all the best setting. Dont have the chance to go test it out too much the roads are solid ice i will have to wait for the morning. Pretty much my only question is approximately what ratio do i want between the set and the gain for low and high settings? I just want to start off at 8 psi and work my way up. I have a ddp, catless 3 inch exhaust, intake, bov, stock ct.
 
Last edited:

becauseican

Supramania Contributor
Mar 31, 2005
1,451
0
0
Vancouver
www.bicperformance.com
Its a little trickey to set up, you need to play with it for a while to get it right. With a stock type setup you will probably just need one setting , and then you can turn it off for the low setting. I think that the SET GAIN is in psi, but the SET is a % of duty cycle. I would start with the set and slowly turn up the SET until the boost goes where you want it. Once you have that done then you can play with the START BOOST for wastegate response. If you have creep or spike problems than you use the SET GAIN as per instructions to dial it out.

Randy