You see where the clip is on the vertical bracket. Unclip It and use that hole for the upper bracket.
Spearco intercooler install help
- Thread starter Doat
- Start date
Doat;2020873 said:I tried that the vertical bracket only has bolts that go from front to back and the bracket that came with the intercooler goes left and right. Seems like it's for a pre-89, so far I have added a bracket for the bottom so now it's held on with 2 bolts instead of 1 and I need to figure out how to support the top here is what my vertical bracket looks like to the left is the front of the car for reference.
That is for the vertical mount right? I was thinking about that too I'll have to check again to see if it lines up where I can get a bolt through. The bottom mount fits perfectly with a bolt hole on the chassis so that one has to be for the bottom of the intercooler.
Where the black nipple is. But the bracket will go on the other side because of the lip on this side won't allow it to sit flush.
Yea the clip that holds the horn wires to the bracket right? I'll fiddle with it again and see if it will line up.
Doat here is my spearco intercooler bolted on the bottom.
http://i30.photobucket.com/albums/c322/dmp316/IMAG0463.jpg
http://i30.photobucket.com/albums/c322/dmp316/IMAG0463.jpg
Yea I got the bottom mount on correctly the top mount is the one I need help with lol. I just got back from California, so I am going to mess with it tomorrow.