sp61 on a 7mgte
- Thread starter boostedma70
- Start date
That sounds good to me won't be till like early/mid summer. where are you located your thing says Washington. so if that's Washington state that's not a big deal for me to drive that far.
Ok last question I have well more of an approval. I would need the gm map sensor, the gm temp sensor, and the splice in boost controller harness with the Maft pro right?
Start Poking around here - http://www.turboninjas.com/supra/maft/
It's pretty straight forward and fun to tune if you have a laptop so you can log runs. The fullthrottletech.com forums are up and down, if you can't get on just email the http://www.fullthrottlespeed.com and they usually get it going again.
Go Speed density and set up all the features - Timing Monitoring, Timing Control, Enhanced Throttle Position, Boost Control, VF Monitoring.
:icon_bigg Kenny can you post your BIN's? I'm tuning 5.27 with a modified GrimReaper 5.21 cloose loop 0 mainscale User Axis VE Table.
It's pretty straight forward and fun to tune if you have a laptop so you can log runs. The fullthrottletech.com forums are up and down, if you can't get on just email the http://www.fullthrottlespeed.com and they usually get it going again.
Go Speed density and set up all the features - Timing Monitoring, Timing Control, Enhanced Throttle Position, Boost Control, VF Monitoring.
:icon_bigg Kenny can you post your BIN's? I'm tuning 5.27 with a modified GrimReaper 5.21 cloose loop 0 mainscale User Axis VE Table.
boostedma70;1791525 said:
wish i would i seen this thread last week i just sold my maf gen2 for $150 with senors and ls1 maf and housing with reducers for 2.5in ic pipping
boostedma70;1794248 said:
If you have everything listed in the 'Speed Density' kit, then you'll be set. You can get the boost controller kit also if you like. I'm not running that because my Greddy ProfecB SpecII works waaaay to good.
terrenceLP;1794253 said:
Grim did get the ETPS feature to work; but, it causes a TPS Code to be thrown. It's been debated whether or not that's a good thing to have stored.
I can post my BIN; but, I'm running a version that no one else is. Not that I'm anything special. It's just that I was working with the developer on the Timing Feature and have a beta release.
Also, since I'm injecting Meth, my tables won't be of much use to you "Pump Gas" guys.
View attachment terrence_bins_logs_5.28.zip - 5.28 - added support for AEM UEGO Analog
Take a look, my boost is nice and smooth, still running a tad rich in some areas but my ETP has yet to through a code as I'm running Mode 2 - TPS And RPM where as Mode 1 is TPS OR RPM.
Take a look and tell me what you think.
Car is fast and starts building boost @2495.
Take a look, my boost is nice and smooth, still running a tad rich in some areas but my ETP has yet to through a code as I'm running Mode 2 - TPS And RPM where as Mode 1 is TPS OR RPM.
Take a look and tell me what you think.
Car is fast and starts building boost @2495.