Some pics after getting lower

[SC61 MK3]

I wasn't happy how the car was sitting on my eibachs and tokico setup. way too much gap in the rear. the 16 inch mkiv rims didnt help either. so i took the cutoff wheel and cut off 1 coil from the rear springs. now it rides the same and i think looks better. here are some pics

 

[SC61 MK3]

if the pics arn't all loading try this in a new window

http://www.we-todd-did-racing.com/wetoddimage.wtdr/wODYwMDg3NnM0MTNkZmQzMXk1NDE=.jpg

http://www.we-todd-did-racing.com/wetoddimage.wtdr/wODYwMDg5NnM0MTNkZmQzMXk1NDE=.jpg

http://www.we-todd-did-racing.com/wetoddimage.wtdr/wODYwMDk2NnM0MTNkZmQzMXk1NDE=.jpg

http://www.we-todd-did-racing.com/wetoddimage.wtdr/wODYwMDk3NnM0MTNkZmQzMXk1NDE=.jpg

 

[Shinobu]

The rear looks a bit lower than the front but otherwise looks great. Really like what you did with the front end also.

 

[SC61 MK3]

the driveway is at a slope. on an even surface the front is lower and rear a bit higher

dont mind the oil stains from all the messy projects in the driveway

 

[Carls91Supra]

So the front is untouched eibachs, looks low compared to mine? Looks nice though I gotta do the same thing to mine, but only to the stock rear springs

 

[VanSupra]

You should cut the fronts the same as the rears to keep the correct profile. Low in the rear is good if you're not planning on a high speed front end float show..

 

[SC61 MK3]

the front was alot lower than the rear. i guess i need some better pics on a flat surface. yes the front eibachs springs are un touched.