seat removal HELP

[daledoe]

I have a bit of a problem......... I'm striping my parts car and can't get at the drivers seat bolts because the seats to far forward. The car has no power because theirs no motor or wiring. Any ideas!!!!!!!!!! :icon_evil

 

[figgie]

Well last I checked you should be able to get a flat wrench in there with no problems.

 

[suprahero]

Find the wires that go to the seat and connect them to a 12v battery and it should work fine. If it's being parted anyways, it's not going to hurt to cut the wires.

 

[daledoe]

I'm using the seats so I don't won't to cut it. The car has been siting for like 5.5 years and the passenger seat was a bitch. I had to use a pipe. O'well guess I'll just have to use a wrench and a can of pb blaster

 

[black89t]

a good 14mm box end wrench will do it. i had the exact same problem when i parted out my crashed car. no power to the seat. use the box end on the bolt then use a 17mm box end on the openside for more leverage. that how i did it. worked in no time.

 

[daledoe]

That will work but for some reason the seat is all the way forewords!!!!!!!!! not alot of room, I'll deal with it.

 

[shenronzero]

That will work but for some reason the seat is all the way forewords!!!!!!!!! not alot of room, I'll deal with it.

just put a battery in the the car... you dont need a key its a constant

GL

 

[daledoe]

Theres no wiring in the car except in the dash. Frame, struts, wheels, rug, dash, doors, hatch, and that one damb seat. Thats it!!!!!!!!!

 

[shenronzero]

Theres no wiring in the car except in the dash. Frame, struts, wheels, rug, dash, doors, hatch, and that one damb seat. Thats it!!!!!!!!!

can u reach under the seat and unplug the wire... i can tell you how to get it out if you can do that.

 

[shenronzero]

hey i figured out how to do it... give me like to and i will upload the pics and tell you what to do

 

[shenronzero]

ok so you are going to go to the right rear of the drivers seat and there is going to be a three piece plug with a blue and white wire side by side. your going to unplug it (you may have to rip the one part down from the bottom of the seat, its only a plastic clip) then you need to take some speaker wire and put some plug ends on one side and strip the other side. plug the two wires into the side by side ones (blue and white). with the are striped end you are going to take a car battery or battery from a drill and touch the blue to + and the white to -. this will get your seat to move

note: i believe to controls were backwards, foreward was back... i may have just turned the wires around but it did work

GOOD LUCK

 

[daledoe]

Nice thanks man!!!!!!!!!!!! :icon_razz:thumbup: