I came across this page on how to setup the A'pexi safc and I know on the Jdm 2j it uses a map sensor instead of Maf so I have it set to pressure. Now when it comes to TH point, graph scale and NE point are they the same? Just want to confirm this, thanks
A'PEXi S-AFC Installation
First start off by Resetting the AFC. Many have often complained that their AFC does not show full throttle(%100), regardless if it is brand new. Go under [etc.] and press NEXT~>. Confirm "YES" when prompted "Init. All?" and press NEXT again, Now turn the ignition OFF and then back ON, and the unit should now be reset and ready.
Next enter the following basic settings:
-Go to [main] ~>[setting] ~> [3. TH-Point] ~> [Lo-94, Hi-95]
-Go to [main] ~>[etc.] ~> [1. Sensor Type] ~> [1. Hot-Wire] ~> [in-12, Out-12] ~> [in-1, Out-1]
-Go to [main] ~>[etc.] ~> [2. Car Select] ~> [Cyl:6, Thr: UP]
-Go to [main] ~>[etc.] ~> [3. Graph scale] ~> [Ne = 7000rpm]
[Ne-POINT = 3500, 4000, 4500, 5000, 5500, 6000, 6500, 7000]
[Dec. -Air = NOT USED, unless you want to use it to compensate for venting your BOV to atmosphere]
A'PEXi S-AFC Installation
First start off by Resetting the AFC. Many have often complained that their AFC does not show full throttle(%100), regardless if it is brand new. Go under [etc.] and press NEXT~>. Confirm "YES" when prompted "Init. All?" and press NEXT again, Now turn the ignition OFF and then back ON, and the unit should now be reset and ready.
Next enter the following basic settings:
-Go to [main] ~>[setting] ~> [3. TH-Point] ~> [Lo-94, Hi-95]
-Go to [main] ~>[etc.] ~> [1. Sensor Type] ~> [1. Hot-Wire] ~> [in-12, Out-12] ~> [in-1, Out-1]
-Go to [main] ~>[etc.] ~> [2. Car Select] ~> [Cyl:6, Thr: UP]
-Go to [main] ~>[etc.] ~> [3. Graph scale] ~> [Ne = 7000rpm]
[Ne-POINT = 3500, 4000, 4500, 5000, 5500, 6000, 6500, 7000]
[Dec. -Air = NOT USED, unless you want to use it to compensate for venting your BOV to atmosphere]